Skip to content

WaytoICT

通往ICT之路 · 光通信与AI网络技术解读

中文English
登录注册
Menu
Technology Optical comms · silicon photonics · CPO → Market Insights Financials · trends · industry → In-Depth Analysis Optical chips, devices & modules → Video Understand a topic in minutes → Documents Latest docs · summit materials →
Menu

Eoptolink: HYBRID, LPO, LRO and DSP

Posted on 2026-01-15 by

In the current field of optical transceiver technology, the four schemes of DSP, LPO, LRO, and HYBRID will coexist for a long time, each serving different transmission needs and application scenarios.

Eoptolink: HYBRID, LPO, LRO and DSP

Full DSP refers to equipping complete DSP at both the transmit and receive ends, with the strongest signal processing capability, supporting medium- and long-distance transmission, with a mature industrial chain and plug-and-play capability.

Eoptolink: HYBRID, LPO, LRO and DSP

But its power consumption is relatively high (800G modules usually exceed 14-16 W), the latency is larger, and the cost is also the highest, mainly used in metro networks, backbone networks, and core links with extremely high reliability requirements.

The LPO scheme completely removes the DSP inside the module, moving the signal processing function to the host-side SerDes.

Eoptolink: HYBRID, LPO, LRO and DSP

Its advantage lies in the lowest power consumption (30-50% lower than DSP), extremely low latency, and the lowest module BOM cost.

The disadvantage is that it places extremely high requirements on the host SerDes and channel consistency, with a transmission distance usually limited to within 100 meters, complex system debugging, and an ecosystem still under development. It is mainly suitable for ultra-short-distance interconnection within or between AI cluster racks.

The LRO scheme retains the DSP only at the transmit end, with linear reception at the receive end.

Eoptolink: HYBRID, LPO, LRO and DSP

Its power consumption and transmission distance are between those of DSP and LPO. However, because it uses a highly customized transmit-side simplex DSP, it has the fundamental problem of poor chip generality and difficulty in scaling, so it has not become a mainstream scheme.

The HYBRID scheme is different from the above, and can be said to be a comprehensively optimized architecture. Inside the module, it lets only half of the transmit/receive channels go through DSP processing, while the other half uses a linear architecture.

Eoptolink: HYBRID, LPO, LRO and DSP

For specific technical interpretation and form factor, please refer to:

1.6T/3.2T Optical Transceivers: Half-DSP, Half-LPO Hybrid Architecture

The key difference from LRO is that HYBRID can reuse the mature duplex DSP chips on the market, rather than relying on customized simplex DSP, only reducing the number of channels used.

Therefore, HYBRID has more advantages in chip generality, supply chain stability, and scalability. Actual measurements show that the performance of some of its links is even better than LRO.

Eoptolink: HYBRID, LPO, LRO and DSP

Compared with the full DSP scheme, HYBRID can reduce power consumption by about 20%-30%, significantly reduce latency, and reduce overall cost by about 20%.

In terms of signal quality, for example, a pre-forward-error-correction bit error rate of E-7 to E-8 can be achieved at a multimode distance of 50 meters, and an E-10 level can be reached at a single-mode distance of 500 meters.

Of course, HYBRID requires the host side to cooperate in signal tuning, depends on system-level collaborative optimization, and is still in the early stage of large-scale application.

Recommended reading:

1.6T/3.2T Optical Transceivers: Half-DSP, Half-LPO Hybrid Architecture

HiSilicon / Intel: SiN-SOI Microring Modulator for CPO

Cisco’s Pluggable-Supporting CPO Optical Interface Scheme

Accelink: Some Views on CPO and Its 3.2T Silicon Photonics CPO Scheme

Google’s TPUv7 and Optical Transceivers, OCS Switches

Enjoy this article?

Subscribe to get new optical communication insights delivered to your inbox. Free, unsubscribe anytime.

Category: Technology

Leave a Reply

You must be logged in to post a comment.

订阅更新

订阅后,新文章发布时第一时间收到邮件通知

李东霏
光互连技术研究者

香农信息技术研究院,专注光模块、CPO、硅光与 AI 光互连的技术解读。

行业报告

光芯片·光器件·光模块 2026 报告汇编(含 OFC 2026)

光芯片 · 光器件 · 光模块
2026 报告汇编(含 OFC 2026)

¥1,900

上/下两册,收录 OFC 2026 一线报告
添加微信 WaytoICT 订购

广告

📢 广告位招商:面向全球光通信客户 侧边栏广告位 Email:Dongfei.li@shannoninstitute.cn

最新文档

  • 互连拐点:11 页解析机架内到多机架 Scale-Up 的 XPO/CPX/OCI 蓝图(OCP 2026 全球峰会)
  • AI 时代的相干光技术:17 页解析 Scale-Across、液冷 XPO 与全谱转发器(OCP 2026 全球峰会)
  • XPO 高密度光互连的系统级评估:20 页解析 212G SerDes 平台与 FRO/LRO/LPO 实测(OCP 2026 全球峰会)
  • CPO 与 OCI 标准及未来技术:17 页 Broadcom 精简版演讲提纲(OCP 2026 全球峰会)
  • VCSEL 高密度互连:7 页解析 50G NRZ「慢而宽」阵列与光 PCIe 演示(OCP 2026 全球峰会)

最新评论

暂无评论,欢迎登录后发表第一条评论。

最近访客

👥 今日访客 -
加载中…
© 2026 WaytoICT | 蜀ICP备2020035321号-2 | 隐私政策 | 免责声明
Wechat Pay
Alipay
请使用 支付宝 或 微信 扫码支付