Skip to content

WaytoICT

通往ICT之路 · 光通信与AI网络技术解读

中文English
登录注册
Menu
Technology Optical comms · silicon photonics · CPO → Market Insights Financials · trends · industry → In-Depth Analysis Optical chips, devices & modules → Video Understand a topic in minutes → Documents Latest docs · summit materials →
Menu
EML TEC 文章配图

Why Can’t EML Do Without TEC?

Posted on 2026-10-18 by

The EML lasers we usually see all have a TEC in their structure.

For example, in this kind of TO package, the side of the TEC is closely attached to the thermally conductive substrate, and the EML chip is then attached through the substrate.

TO-packaged EML structure with TEC temperature control

There is also a structure like this:

Another EML package structure with TEC

The principle of TEC is the thermoelectric cooling effect, that is, the Peltier effect: two different semiconductors form an electrical junction, and after power is applied, one side absorbs heat and the other releases heat, realizing active temperature control.

Animation of the Peltier effect

Extended reading: UESTC: CPO Co-Packaging Scheme Based on Micro-Channel Liquid Cooling

The EML itself integrates a DFB laser emission region and an EAM electro-absorption modulation region on the same chip. The front DFB section is responsible for emitting light, and the rear EAM section is responsible for controlling the light.

EML chip structure: DFB laser emission region and EAM electro-absorption modulation region

Recommended reading:
Lumentum: Progress of 4x200G Differential-Drive EML
Broadcom: 400G EML Evolution Roadmap and Differential-Drive Scheme
Source Photonics: 400G/lane EML Scheme and 3.2T Optical Module Roadmap and Viewpoints

The EAM controls the on/off of light through voltage. In normal mode, when no voltage is applied, it is “transparent” to light of a specific wavelength; when a reverse voltage is applied, it becomes “opaque” and absorbs the light.

Schematic of EAM voltage controlling light on/off

The schematic of the absorption characteristics of the I region in the optical transmission area is as follows.

Schematic of the absorption characteristics of the EAM optical transmission region I region

The DFB laser emits light continuously during operation, and its emission wavelength and power characteristics are shown in the figure below.

DFB laser wavelength drift characteristic: about 0.1nm/degC

When a reverse voltage is applied, the DFB wavelength exactly falls at the center of the absorption valley, the light is strongly absorbed, the transmitted power is very low, and the output is logic “0”.

With reverse voltage, the DFB wavelength falls in the absorption valley, outputting logic 0

When no voltage or only low voltage is applied, the absorption valley shifts, the DFB wavelength moves out of the absorption valley into the transmission region, the transmitted power is very high, and the output is logic “1”.

With no voltage, the absorption valley shifts, outputting logic 1

Expressed with the absorption curve, when the voltage is 0V, the edge of the absorption spectrum is far from the laser wavelength, and the modulator hardly absorbs light.

At 0V, the edge of the absorption spectrum is far from the laser wavelength

If Δλ is too small, the laser wavelength is close to the EAM absorption edge, and even at 0V the absorption is extremely strong and the output is extremely low. Although this can improve the extinction ratio, it causes insufficient logic “1” power, affecting performance.

Returning to our original question, it is easy to explain why TEC temperature control is needed for the EML.

In the TO package mentioned earlier, the EML chip generates heat during operation. As the temperature rises, the DFB wavelength red-shifts toward longer wavelengths at a rate of about 0.1nm/degC.

Temperature rise causing DFB wavelength red-shift and mismatch with the EAM absorption valley drift

The EAM absorption valley also red-shifts, but the two drift at different rates.

The EAM absorption valley is a narrow window, and modulation relies entirely on the precise matching between the DFB wavelength and the edge of the absorption valley. Once the temperature changes, the positions of the two deviate, causing the problem that the off-state cannot absorb completely and the on-state cannot transmit through.

Therefore, TEC precise temperature control is needed to stabilize the matching between the wavelength and the absorption valley, allowing the EML to work stably in various environments.

Related reading:
Alibaba: Failure Analysis of 400G Optical Modules in AI Networking Scenarios
Broadcom: 400G EML Evolution Roadmap and Differential-Drive Scheme

You can add WeChat WaytoICT to be invited to join the Semiconductor & Optical Components Industry Chain Group 2.

Welcome to join our community to obtain high-value technical documents, trend research reports, and various supply-demand business opportunities in the fields of semiconductor chips / optical components / optical modules.

WaytoICT report compilation and services

If you are interested in semiconductors / optical components / optical modules / optical fiber communication, welcome to follow us!

Enjoy this article?

Subscribe to get new optical communication insights delivered to your inbox. Free, unsubscribe anytime.

Category: Technology

Leave a Reply

You must be logged in to post a comment.

订阅更新

订阅后,新文章发布时第一时间收到邮件通知

李东霏
光互连技术研究者

香农信息技术研究院,专注光模块、CPO、硅光与 AI 光互连的技术解读。

行业报告

光芯片·光器件·光模块 2026 报告汇编(含 OFC 2026)

光芯片 · 光器件 · 光模块
2026 报告汇编(含 OFC 2026)

¥1,900

上/下两册,收录 OFC 2026 一线报告
添加微信 WaytoICT 订购

广告

📢 广告位招商:面向全球光通信客户 侧边栏广告位 Email:Dongfei.li@shannoninstitute.cn

最新文档

  • 互连拐点:11 页解析机架内到多机架 Scale-Up 的 XPO/CPX/OCI 蓝图(OCP 2026 全球峰会)
  • AI 时代的相干光技术:17 页解析 Scale-Across、液冷 XPO 与全谱转发器(OCP 2026 全球峰会)
  • XPO 高密度光互连的系统级评估:20 页解析 212G SerDes 平台与 FRO/LRO/LPO 实测(OCP 2026 全球峰会)
  • CPO 与 OCI 标准及未来技术:17 页 Broadcom 精简版演讲提纲(OCP 2026 全球峰会)
  • VCSEL 高密度互连:7 页解析 50G NRZ「慢而宽」阵列与光 PCIe 演示(OCP 2026 全球峰会)

最新评论

暂无评论,欢迎登录后发表第一条评论。

最近访客

👥 今日访客 -
加载中…
© 2026 WaytoICT | 蜀ICP备2020035321号-2 | 隐私政策 | 免责声明
Wechat Pay
Alipay
请使用 支付宝 或 微信 扫码支付