Usually, photoresist is only used as a temporary mask in the pattern-construction step. Therefore, the final step of the lithography process is usually to remove the photoresist, which we call stripping or resist removal. The requirements for the stripping process are: remove the resist quickly without residue, and cause no damage to the substrate or…
Technology
Broad-Area Laser Diodes
A broad-area laser diode (also called a broad-stripe laser diode, multimode single-emitter laser diode, broad-emitter laser diode, single-emitter laser diode, or high-brightness diode laser) is an edge-emitting laser diode whose front-end emission region is shaped as a broad stripe, typically 1um (height) x 100um (width). Due to the asymmetry of the emission region, the beam…
What is the Principle of Direct Detection?
A directly modulated laser (DML) can be used to modulate optical power. In a DML, the laser output power is adjusted by changing the pump current in the laser gain medium. As shown in the figure below, the pump current is controlled by an electrical drive signal. The modulation format of this type of direct…
What is Direct Detection?
In the field of communications, the direct detection (DD) system is a very practical technology. It realizes information transmission by detecting the modulated optical power (also commonly referred to as the optical field intensity or light intensity). In a traditional DD system, the receiving end mainly consists of a photodiode (PD), while the transmitting end…



