Although the final microchips are rectangular, silicon wafers are round during manufacturing. This is because the circular design offers many advantages in the production process, and round wafers are also easier to handle in subsequent processing. However, since microchips are rectangular, there are always some regions on a round wafer that cannot be fully utilized,…
What Is Photoresist Stripper, and How Do You Choose One?
Usually, photoresist is only used as a temporary mask in the pattern-construction step. Therefore, the final step of the lithography process is usually to remove the photoresist, which we call stripping or resist removal. The requirements for the stripping process are: remove the resist quickly without residue, and cause no damage to the substrate or…
Broad-Area Laser Diodes
A broad-area laser diode (also called a broad-stripe laser diode, multimode single-emitter laser diode, broad-emitter laser diode, single-emitter laser diode, or high-brightness diode laser) is an edge-emitting laser diode whose front-end emission region is shaped as a broad stripe, typically 1um (height) x 100um (width). Due to the asymmetry of the emission region, the beam…
What is the Principle of Direct Detection?
A directly modulated laser (DML) can be used to modulate optical power. In a DML, the laser output power is adjusted by changing the pump current in the laser gain medium. As shown in the figure below, the pump current is controlled by an electrical drive signal. The modulation format of this type of direct…



